Anthropometric Analysis of the Anterior Maxillary Fixation Points – A Step in Optimizing L-plates for Zygomaticomaxillary Fractures
DOI:
https://doi.org/10.32412/pjohns.v40i2.2637Keywords:
maxillary fractures, zygomaticomaxillary buttress, tomography, spiral computed, titanium, fracture fixation, internalAbstract
Objective: To determine and group the anthropometric norms of the zygomaticomaxillary (ZM) fixation points as a basis for optimizing the design of maxillary L-plates, from a sample population aged 19 to 59, in a tertiary government hospital in Central Luzon, Philippines.
Methods:
Design: Retrospective Review of CT scans
Setting: Tertiary Government Training Hospital
Participants: CT scan images of 110 surgical patients from the Department of ORL-HNS, obtained between January 2023 and December 2024 were measured
Results: A total of 169 maxillae were analyzed, comprising 85 right and 84 left sides. The maxillary width (MW) of males (30.59 ± 2.86 mm) was found to be wider than the MW of females (29.68 ± 2.69 mm) by 0.91 mm. The zygomatic width (ZW) and its inclination angle (IA), on the other hand, were not significantly different. There were also no significant differences in the MW, ZW, and IA between the right and left sides; with the MW mean at 30.17 ± 2.81 mm and a range of 24.40 36.80 mm, the ZW mean at 20.22 ± 2.47 mm and a range of 15.40–28.30 mm, and the IA mean at 111.13 ± 11.29 degrees and a range of 78.50–131.70 degrees. To capture the range of maxillary sizes among patients, a quartile-based grouping was introduced. The MW, ZW, and IA of the L-plates were classified into small (27.80 mm, 18.30 mm, 104.15 degrees), medium (29.80 mm, 19.90 mm, 110.70 degrees), and large (32.35 mm, 22.05 mm, 120.20 degrees) sizes, respectively.
Conclusion: This study established reference values for the MW, ZW and IA to optimize the maxillary L-plate design for ZM fractures. The novel quartile-based grouping provided options for future L-plate measurements – potentially creating a better fit for patients, streamlining design in implant production, and improving the efficiency and outcomes of maxillofacial surgeons.
Downloads
Published
How to Cite
Issue
Section
License
Copyright (c) 2025 Publisher
This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.
Copyright transfer (all authors; where the work is not protected by a copyright act e.g. US federal employment at the time of manuscript preparation, and there is no copyright of which ownership can be transferred, a separate statement is hereby submitted by each concerned author). In consideration of the action taken by the Philippine Journal of Otolaryngology Head and Neck Surgery in reviewing and editing this manuscript, I hereby assign, transfer and convey all rights, title and interest in the work, including copyright ownership, to the Philippine Society of Otolaryngology Head and Neck Surgery, Inc. (PSOHNS) in the event that this work is published by the PSOHNS. In making this assignment of ownership, I understand that all accepted manuscripts become the permanent property of the PSOHNS and may not be published elsewhere without written permission from the PSOHNS unless shared under the terms of a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International (CC BY-NC-ND 4.0) license.
